When the 40-layer M6G high speed PCB is close to the parallel high-speed differential signal line pair, in the case of impedance matching, the coupling of the two lines will bring many advantages. However, it is believed that this will increase the attenuation of the signal and affect the transmission distance.
Megtron6 high speed PCB needs not only high-speed components, but also genius and careful design. The importance of device simulation is the same as that of digital. In high speed system, noise is a basic consideration. High frequency will produce radiation and then interference.
The process of Meg6 high speed PCB design is usually: Layout - pre wiring simulation - change layout - post wiring simulation, and the wiring is not started until the simulation results meet the requirements.
It is generally believed that if the frequency of a digital logic circuit reaches or exceeds 45MHZ ~ 50MHZ, and the circuit operating above this frequency has already occupied a certain portion of the entire electronic system (say 1/3), it is called a high-speed circuit. The following is about R5775G High-speed PCB related, I hope to help you better understand R5775G High-speed PCB.